Painting
Removing gotelé: price per m², methods and how long it takes
· 5 min

Removing gotelé, the textured paint finish common on Spanish walls, costs from €12 per square metre of wall in Barcelona, with repainting included. There are two ways to do it: wet and scrape it, when the texture softens with water, or skim plaster over it and sand until the wall is smooth, when it has been painted with emulsion or enamel and won’t come off. A normal room takes two to three working days including drying time, and a flat of about 60 m² takes six to ten.
What removing gotelé costs
| Job | Guide price |
|---|---|
| Removing or skimming gotelé, painting included | from €12/m²* |
| Room of 3 × 4 m: about 35 m² of wall | from €420* |
| Painting smooth walls, two coats, for reference | from €8/m²* |
*Guide prices. You receive the final figure in writing, broken down item by item, once we’ve tested the gotelé and seen the walls.
The price is based on the wall or ceiling area treated, not on the floor area. Coarse-grained gotelé, a textured ceiling, walls with many cracks or flaking underneath and high ceilings push it up. An empty flat and walls in good condition bring it down.
The sponge test
Before choosing a method, you need to know what kind of gotelé you have. The test is simple: soak a patch of about 30 × 30 cm in an inconspicuous spot with a sponge, wait ten to fifteen minutes and run a scraper over it. If the texture softens and peels away, it can be scraped. If it stays hard, it is sealed by a paint that keeps water out.
Method 1: wetting and scraping
This works with gotelé made from distemper or water-based paint that has never been repainted with emulsion, which you still find in some flats from the 1970s and 80s that have changed little. The wall is wetted section by section, scraped, the defects underneath are repaired, it is lightly sanded, sealed and painted.
- Pro: the wall returns to its original state, with no added layers.
- Pro: wet scraping raises hardly any dust; it is messy, but with sludge that can be collected.
- Con: the plaster underneath is often uneven and has to be repaired before painting.
- Con: sockets and floors must be well protected from water.
Method 2: skimming and smoothing
This is the usual method when the gotelé has been painted with emulsion, enamel or oil-based paint, very common in kitchens, hallways and stairwells because it was easy to wash. Water can’t get through, so scraping is pointless. The peaks of the texture are lightly sanded off, a bonding primer goes on if the paint is glossy, filler is skimmed on in one or two coats, sanded smooth, sealed and given two coats of paint.
- Pro: works on almost any gotelé that is firmly bonded.
- Pro: corrects minor unevenness in the wall at the same time.
- Con: sanding produces fine dust; the room has to be sealed off, vacuumed and worked in with protection.
- Con: adds a few millimetres of thickness, noticeable where the wall meets frames and skirting boards.
If the gotelé is coming away in sheets or the wall is damp, neither method works without first making good: loose material is removed, the cause of the damp is dealt with, and only then is the wall skimmed.
How long it takes
| Area | Guide duration |
|---|---|
| Room of 10–12 m² floor area | 2–3 working days* |
| Living room of 20–25 m² floor area | 3–4 working days* |
| Whole flat of about 60 m² | 6–10 working days* |
Most of the time is drying: filler has to dry before sanding, and each coat of paint before the next. In winter, or in poorly ventilated interior flats in Sants or Horta, drying takes longer. In an empty flat several rooms can be worked on at once, which shortens the total.
Dust and protecting your home
- We seal the room with plastic sheeting and tape, doors and vents included.
- Floors are covered with board or protective sheeting and furniture with plastic.
- We vacuum during sanding and at the end of each day.
- Sockets and switches are protected, especially with the wet method.
- If you are living in the flat, we go room by room so the rest stays usable.
If you are unsure about a very old or unusual textured coating, don’t sand it before checking with us: we look at it during the visit and tell you how to deal with it.
If you want gotelé removed from one room or the whole flat, send us close-up photos and the approximate floor area. We reply within 24 working hours, do the test during the visit and send you a written quote, with the method and the painting included. We work across Barcelona and the whole metropolitan area.
Frequently asked questions
Questions on this topic
From €12/m²* with repainting included. A 3 × 4 metre room with a 2.60 m ceiling has about 35 m² of wall, so the job starts at around €420*. If the ceiling is textured too, its area is added.
Wet a small patch with a sponge, wait ten to fifteen minutes and try a scraper. If the texture softens and comes away, it can be wet-scraped. If it stays hard, it has most likely been painted with emulsion or enamel, and the practical option is to skim over it.
Scraping takes the wall back to its original surface with no added layers, but it only works if the gotelé softens with water. Skimming works on almost any firmly bonded gotelé, involves more sanding and adds a few millimetres of thickness. Once painted, the result is similar if the preparation is done properly.
Yes, room by room. We seal the room with plastic sheeting, protect floors and furniture and vacuum the sanding dust. That room can’t be used for those days.
That is not typical of gotelé in Barcelona flats. If you are unsure about a very old or unusual textured coating, don’t sand it before asking: we look at it during the visit and, if necessary, a sample is tested.